What’s in the box

  • 1 Scooch Wingmount
  • 2 Magnetic Steel Badges for non-Scooch cases
  • 1 Set of Wet & Dry Wipes for dashboard cleaning
  • 1 Extra 3M Adhesive (for repositioning)

Installation Instructions

  1. Find a spot on your dashboard in a good viewing position. The best location is a flat, shiny plastic surface.
  2. Use the included wet wipe to clean the area.
  3. Use the dry wipe to remove any remaining moisture, dust, or residue.
  4. Press the mount firmly onto the cleaned spot and hold for 15 seconds.
  5. Place your device onto the newly affixed Wingmount and enjoy!

How to remove the Wingmount (if needed)

  1. Use an old credit card or dental floss to work under the adhesive and gently remove it. DO NOT pull the Wingmount straight off—this may damage your dash or the Wingmount.
  2. Remove any remaining adhesive from the bottom of the Wingmount.
  3. Apply the included extra adhesive to the base of the Wingmount.
  4. Choose a new spot on your dashboard.
  5. Repeat the installation steps above.

FAQ

Will my case work with the Wingmount?
Yes. The Scooch Wingmount is universally compatible, and works best with Scooch cases. It works natively (no steel badge needed) with:
  • Wingman
  • Wingmate
  • Moneymate + Mounting Card
  • Wingback
  • MagCase + MagWallet combination
If you don’t have a Scooch case, apply one of the included steel badges to the back of any flat, non-textured phone case and you’re good to go.
If I have a Scooch case, do I need the steel plate?
Most likely not. The products listed above connect natively to the Wingmount. Only use a steel badge if your case isn’t on that list or isn’t flat.
Where should I put the steel plate?
Place it on the outside of your phone case, about an inch above or below center. If your case is ≤1 mm thin, you can place the badge on the inside of the case.
Are the magnets in the Wingmount safe for my phone and credit cards?
Yes. Your cards are 100% safe. The steel plate absorbs the magnetic field, and Scooch cases with embedded steel also absorb magnetism. We’ve tested this for years.
Does the steel plate work with wireless charging?
Unfortunately, no. The steel plate interferes with wireless charging.